| |
Phone
connection
LaserShield® plugs into an existing telephone jack.
Power connection
LaserShield® receives its power from a standard wall outlet via a
small low voltage transformer.
Panic button
The 24-hour panic button remains active whether the system is armed
or disarmed. Pressing the panic button at any time will immediately
activate the siren and initiate a call to the 24 X 7 Rapid Response
Monitoring Service through your existing phone line. The Keychain
Remote also includes a panic feature by pressing both buttons
simultaneously.
Siren speaker
When an alarm condition exists the LaserShield® Master Alarm Unit
sounds a 105-decibel siren. Sirens are an active and very important
line of defense against burglary. The majority of intruders leave
immediately when a siren is activated.
Instant Learn Feature
LaserShield® systems are expandable. Additional Wireless Detection
Units or Key Chain Remotes can be learned into your system in less
than 60 seconds. Our proprietary user interface eliminates the need
for programming, complex manuals, allowing an entire system to be
setup or expanded in minutes.
Battery back-up
Each LaserShield® device is equipped with a backup battery, used in
the event of lost power. The Master Alarm Unit battery is
rechargeable and the Master Alarm Unit will notify your monitoring
service if the battery charge becomes low. Other devices such as
Wireless Detection Units and Keychain remotes report their battery
condition to the Master Alarm Unit, which will notify you if a
battery needs to be replaced.
Placement of unit
Each LaserShield® Wireless Detection Unit is equipped with a
state-of-the-art passive infrared detection system. The unit's view
of detection spans out from the front of the unit in a 110-degree
pattern ranging over 35 feet. Delivering approximately 1100 square
feet of detection. The LaserShield® motion sensors samples the
ambient room temperature and will detect an intruder's body heat
moving across its detection zones.
Pet Friendly
A unique Pet Shield instantly snaps into place on the front of the
LaserShield® motion detector on the Wireless Detection Unit. The Pet
Shield blocks portions of the motion sensor so your pet is less
likely to trigger an alarm.
Light and sound effects
LaserShield® will verbally annunciate when it is placed in an armed
or disarmed condition. The Master Alarm Unit counts down the number
of seconds left when arming as a reminder of the 60-second exit
delay. The Master Alarm Unit will also beep for 20 seconds upon
re-entering as a reminder to disarm the system.
Diagnostics
The LaserShield® Master Alarm Unit includes extensive
self-diagnostics. The Master Alarm Unit will report any abnormal
condition such as loss of power, telephone connection disconnected,
or low back-up battery.
User Call Feature
The LaserShield® Master Alarm Unit has a special “phone in” feature.
Using a secret PIN number our customers can telephone their alarm
system from a remote location using a telephone or cellular phone.
This feature allows them to check system status, remote arm, remote
disarm, or even activate a hidden microphone to listen in on
babysitters, children, or pets.
Alarm reporting
The Master Alarm Unit will contact the Rapid Response Moniting
Service to report the following conditions- alarm, panic, low
battery, and cancel. Under normal conditions Lasershield reports the
fastest response time in the alarm industry, initiating a return
phone call approximately 30 seconds after receiving an alarm signal. |
|
